My 2001 7.3 diesel gets 17mpg city or highway 50mph or 70mph. Towing a 10,000 lbs trailer mileage drops to around 13 or 14mpg.
How do you change the alternator on a 1996 ford F350 diesel
how do you replace a fitting from a high pressure oil pump that is leaking oil in a 2001 ford F350 diesel truck?
It seems to be around 13/18 city/Hwy
The towing capacity of a 2001 Ford F350 dually diesel 4x4 truck is 8,250 pounds. This allows the truck to safely transport all but the largest trailers and boats.
where does the oil pressure regulator on a ford f350 diesel truck
14-19 mpg just depends on what kind of drive train
Where is the belt tensioner on a ford 2003 f350 6l diesel? i need to loosen so that i can replace the alternater
they are aproxametly 7,000 pounds depending on how they are equiped
Their isn't one. It used a TP sensor which is controlled by you and the PCM adj throttle accordingly.
how do i down load a wiring diagram for a f350 6.0 diesel engine compartment
the fuel pump on a 2001 ford f350 is located on the inside of the frame underneath the drivers side door
what is the gross gvw for f350 with 3.73 rear trailer max weight
Where is the water drain for the Water in Fuel light?
speed control doesn't work what do you look for
29 or 38... Pending your wheelbase.
2006 Ford F350 Replaceing Alternator
MY EXPERIENCE WAS 12-13 MPG WITH NO MOD'S
If you are the owner of a Ford F350, you should check your owner's manual. If you do not own the vehicle you can either check online at the Ford website, or visit your closest Ford dealership.
No, the 2003 Ford F350 rims will not fit on a 1999 Ford F350.
i need the diagrames for the suspension of a 1994 ford f-350 2wd
ive done a wrecker conversion but running my chip, exhaust, intake, and with my 4.10 rear end i top out at 97mph
6.0L Power Stroke Diesel 2003 - 2007 F250, F350 pickup and F350+ Cab Chassis, 2003 - 2005 Excursion and 2003 - 2009 vanSPONSORED BY:
Yes, the rims off a 2002 Ford F350 will indeed fir on a 1999 Ford F350.
bottom of radiator has plug normally 19mm wrench do not tighten to much it will break just snug it back.
on the top of motor round black housing
Asked By Wiki User