Clutch pedal.
manual transmission , with no clutch pedal .
A manual (standard) transmission.
Yes you can remove a manual transmission and replace it with an automatic. You will need to buy an aftermarket shifter kit of find a shifter for your vehicle from a junk yard. You will also either have to remove the clutch pedal or replace the pedal assembly
Most use a "clutch" safety switch, usually located at the upper end of the clutch pedal. You must step on the clutch before the vehicle will start
In manual transmission you have to manually switch gears in your car's gearbox. This is done by usings clutch pedal and gearstick. Car with manual transmission is much more responsive to you're driving and is considered far superior to automatic transmission.
There is no neutral safety switch on a 85 fiero with a manual transmission. There is a clutch pedal switch under the dash. The car will start in any gear, as long as the clutch pedal is depressed.
To add a pedal, like when switching to a manual transmission, the brackets will have to be installed. The bracket may have to be modified or custom built to fit.
First of all the vehicle must have a manual or (stick shift) transmission. Then you will... 1.)Turn the key on as you would normally and leave it ON. 2.)Push the clutch pedal to the floor and hold it there. 3.)While holing the clutch put the transmission in 2nd gear. 4.)Have someone else push the vehicle to 10mph or as close as you can get. 5.)Release the clutch pedal and push the gas pedal 1/2". The vehicle will shake a bit and will come to life this is when you need to depress the clutch again as to not stall the vehicle. Easy. 5 steps. Just make sure you have enough room to drive the car. ALSO** you can substitute step 4 if you can get the vehicle to roll downhill
Is it an automatic or manual transmission? If its a manual trans its under the clutch pedal.
A manual transmission does not have a neutral switch. It has a clutch switch, which is on the rod that attaches to the clutch pedal.
If manual transmission - a clutch safety switch usually mounted at the upper end of the clutch pedal under dash area
Changing an automatic to a manual transmission involves a lot of work. First, the brake pedal must be changed to a manual brake/clutch installation. Additionally, a separate bell housing, clutch mechanism, shifter and linkage are required.