0
1987
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is number 1 on the distributor cap for a 1996 Chevy 350 EFI?
at 11 Oclock
How do you convert EFI to Carb on a 1987 Chevy truck 350?
That 87 truck already has a carburetor on it.
Where can you get a efi at for your 350?
Go to an efi specialist like http://www.massfloefi.com and talk to them about their products.
Will a 1994 350 efi engine work on 1989 gmc truck 350 efi?
YES, They are the same engines. There's NO difference what so ever.
Why when your Chevy 350 warms up it starves for gas?
That depends, is it carbureted or EFI? If you have a carburetor I'd suggest the jets, float level, accelerator pump... If it's EFI check the EGR valve, oxygen sensors, scan the computer for a fault.
How do you disable a Chevy duramax speed limiter?
The Chevy Duramax has an amazing top speed of 140 MPH. The Chevy duramax is pushing 350 hp. with 6600 flbs of torqe at 3200 RPMs u can disable it with the PPE Tuner Or Efi Live.
You want to install a 1991 Chevy truck 350 efi system in to your 1969 carberated Chevy 350 truck is it possible?
yes it is possible to swap the two motors but considering the 69 motor is carburated you will need to install the propler wiring harness from the 91 350 into the truck and hook all that up. but the motors will bolt up and go rite into place without a problem
Firing order 1988 Chevrolet 1500 350 efi engine?
Most Chevy v-8's have the firing order of: 1 8 4 3 6 5 7 2
Where is 1 on the distributor 78 Chevy 350 with EFI ignition?
AnswerThe number 1 cylinder on a sbc is always front on drivers side, on dist. cap looking from the front of the car is it at 5 o'clock.
Will a 350 engine from a 1989 Chevy silverado go into and hook up in a 1993 whose 350 went bad?
Yes, the 1989 motor can be used. You will have to transfer the accessories, intake, distributor,etc. over from the 1993 motor to retain the EFI.
Your 89 Chevy conversion van 350 EFI engine stops abruptly on a hot day Pull over and it starts right up drive 5 miles and it happens again What could it be?
Over heating.
Why is the ignition timing set at 0 degrees for a 1987 Chevy pickup 350 efi engine?
Because the engine computer takes over from there and sets it to as close to ideal as possible.Remember to use the special procedure to set it!
