Want this question answered?
Your vehicle has a factory set 5 digit code that operates the keyless entry system. You can also program your own 5 digit personal entry code as long as you know the factory-set code. The factory-set code is located on the owner's wallet card in the glove compartment. If that card is missing, see your local Ford dealer.
Your vehicle has a factory set 5 digit code that operates the keyless entry system. You can also program your own 5 digit personal entry code. The factory-set code is located on the owner's wallet card in the glove compartment.
A Navigator's keyless entry code can be changed by entering your 5 digit factory-given code, pressing 1/2 (within 5 seconds) and then entering your own personal 5 digit code. This doesn't erase the factory code. Hint: Do not use all same numbers.
Simple just type in the factory 5 digit code, then press number 2, then type in your new 5 digit code. You are done
Just a long shot, but check inside the trunk for a sticker.
Smartlock is the trademark name for the electronic immobilisation/keyless entry system fitted to Ford Falcon models from the EBII to the AUI! What this system is is a remote keyless entry system and electronic engine immobilisation system factory fitted in those models between the two mentioned which uses a three digit rolling code in the ECU and the embedded code in the tip of the key - if two of the three digits match, the engine will start! If not, no start!
Enter the five digit factory-programmed code into the keypad. Press the 1-2 button immediately after the factory code has been entered, this must be pressed within five seconds. Enter your preferred five-digit personal code.
The keyless entry pad can use two codes to unlock the doors, the factory code and your own personal code. To program your own personal entry code into the keyless entry pad , select five digits that are not in sequence or use the same button five times. 1 - enter the factory set code 2 - within 5 seconds, press the 1/2 button 3 -within 5 seconds of pressing the 1/2 button, enter your personal code, pressing each digit within 5 seconds of the previous digit. The keyless entry system registers this second code, so you can unlock the doors with the factory code or your personal code.
Under the steering column to the left (near the brake) there is a panel. Take the panel off and with a flashlight you will see a white sticker on the fuse box. The white sticker will have a 5 digit code. That is your factory keyless entry code. Can you believe they were actually going to charge me $50 to do that? Unbelievable. And to reprogram the code all you have to do it punch in the factory code, hold down the 1-2 button, then choose a new 5 digit code (this worked for me, let me know if it works for you as well).
the 5 digit factory code should be on the computer module.on the 2011 F-150 look on the passenger side and find the fuse panel and you will see a white sticker with 5 digits and thats your code to keyless door lock pad
Remove the panel (plastic) beneath steering column. ( 3 screws ) then the metal panel behind it ( 2 screws) you can see the 5 digit factory number on the serial number sticker on fuse box. The method to enter your own key is on download owner manual page 104. It is between the 2 bar codes on right side.
Look under the dash on the drivers side all the way to the left.You will see a white sticker and the 5 digit code is on it!