0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What vehicle uses a Fram TG8A oil filter?
1992 Ford F-150 4.9L is one vehicle that uses this filter.
What does a Harvest King PH-1A oil filter fit?
what will a harvest king ph51 fit oil filter
Where is ES 330 oil filter located?
60 degrees s and 120 degrees n
What is oil capacity of Detroit diesel series 60 in a 1996 Freightliner?
11 gallons with filter
What should a Chevy Avalanche oil pressure gauge read?
40 on idle up to 60 while on the move.
Can the oil filter housing be replaced?
That is a poorly worded question as oil filters have not had housings since the 60's. All oil filters are normally screw-on cans and are totally self contained. However, if you removed the filter and have an outer shell and a paper filter in your hand, you are in big trouble because the threaded filter can base is still on the mount. Now, if you are talking about the oil filter mounting base, it can be replaced by removing three bolts. Check to see if it is available separate from the oil pump.
What year sbc engine uses oil filter L30040 purolator?
From the mid 60's to the mid 90's.
When do you have to change the transmission oil for 2005 Chevy Malibu classic?
if no leaks or problems, they recommend every 60< thousand miles.
What should the oil pressure on a 2003 Chevy Trailblazer be to qulify as in the normal range?
Anything above 5 psi at idle will lubricate your engine. There is no maxim oil pressure for a 2003 Chevy Trailblazer. When the engine is cold and the oil is thick you should see 60 to 80 psi.
Oil pressure on Chevy Tahoe while running?
The oil pressure gauge will fluctuate on a Chevy Tahoe when the vehicle is idling and when the vehicle is driven at highway speed. Idle is usually 30 psi oil pressure or slightly more. At highway speed, the oil pressure should be between 60 psi and 80 psi.
How many quarts of oil in a 1968 Chevy motor?
Most all V8 & inline 6 cylinder engines required 5 quarts with filter change. Just park the car on a level surface, drain the oil and replace the filter. Add 4.5 quarts and start the engine and let run for 60 seconds. Shut off and wait 1 hour. Check the level and add as necessary. You now know the capacity.
How do you change oil on a mercury 60 hp four-stroke outboard?
I just changed the oil in my mercury 60 hp 4 stroke and had very little clean up. I let the oil completely drain from the motor before I removed the filter and had No drips there either. Just over 30 minutes to change motor oil and lower unit oil. Total cost of $35.00 included quicksilver 25W40 quicksilver oil filter and quicksilver 80/90 gear oil. Take your time and save your money . No reason to pay a dealer $150 to $250. for this simple oil change. Charliestoybox
