0
12.7 storm and 1.2 gsi
Clarissa Nitzsche
Add your answer:
Earn +20 pts
What is the fuel injector resistance spec on a 1991 geo storm gsi?
12.7 storm and 1.2 gsi
What is the ohm reading on a fuel injector?
An Ohm reading is the amount of resistance through a fuel injector. A fuel injector is a solonoid that controls fuel delivery. Inside the injector, there is a coil of wire. When you measure the Ohms across the injector, you are checking the amount of resistance in that coil of wire. Each injector manufacturer has their own acceptable measurement, so check with them for proper readings.
How do you clean a 1991 Subaru legacy fuel injector?
Aircompresser
Where is the fuel injector regulator tbi in a 1991 cchevrolet van g20 5.7l ?
Take off the upper intake, the regulator is on the backside of the fuel injector unit spider.
How much Amps is required for fuel injector?
A fuel injector's current draw, measured in amps, is a function of the fuel injector's actual impedance. Your answer is then necessarily dependent upon the impedance of your injectors. To determine your injector's draw, simply divide voltage by ohms. That is, given a 12v circuit and an injector with 12 ohms resistance, the draw is 1 amp (12 divided by 1).
1991 240sx engine light fuel smell?
leaking injector or bad o2 sensor
Where is the Fuel injector fuse location 1991 Chevy van?
don't no ,thats why i'm asking
Where is the fuel pump located on a 1991 Geo Storm?
Fuel pump is in the gas tank and it is not cheap.
1992 Chevy 350 - Why no fuel past tbi?
if there is fuel to the throttle body injector then test the injector itself. is there a pulse from the computer? use a noid light to see pulse. if so does the injector has high resistance? (resistance can be looked up on-line or at your local auto parts store) resistance is the amount of amperage electricity needs to go through something. that's why corrosion on the battery can cause it to fail or the alternator to fail. if all these tests fail, inspect for blockage between the injector and inlet to the TBI unit.
How do you know if you have a bad fuel injector on a 1995 Honda Accord?
If I'm not mistaken, it's just like checking fuel injectors on any other vehicle. You have to know what the resistance is (Honda should be able to give you the specs) remove the connector to the injector, take a multi-meter and set it for "ohms" and put the two probes on the contacts of the injector and you should get a resistance reading, if the reading is not within the manufacturers specs then it's a bad or weak injector. Hope this helps, its the best i can do.
What causes a 1991 RS Camaro with a 305 TBI not to get fuel injector pulse?
if you do not have spark you will not have fuel check coil module and ignition pick up coil.
How do you change a fuel injector in a 1987 Nissan maxima?
Where is the fuel injector located?
