Want this question answered?
12 volts, 12 amps
12 volts is equal to how many mv
Tricky question. 12 Volts, if referenced in AC, would mean a root-mean-squared (RMS) value of 12 Volts. It would also equate to a maximum voltage of about 17 volts. Roughly speaking 12 Volts AC is equal to 12 Volts DC. Just remember that 12 Volts AC isn't always 12 Volts....
12 volts
Watts is volts times amps, so 12 x 30 = 360 watts
Key-on 12 volts, single wire.
If you have 12 volts at the blower, And the blower runs when it is straight wired. The blower switch runs through a resistor that allows the blower to run in low, medium-low, medium-high. Find and check this resistor. Most of the time it is located on the passenger side of the firewall.
Check for 12 volts at the washer pump connector before all else. If you have 12 volts when the button is being pushed (with the key in the on position) your pump is the problem.
Have you made sure your battery is at 12 volts and not 11 volts? Secondly, 11 volts is more than enough to make the pump run (and start the truck). Low voltage is normally the sign of a bad relay (or wire connector).
Yes, it should show 12 volts DC. If not suspect the relay is bad.
The purpose of a 4-pin auxiliary connector on a motherboard is to provide an additional 12V power supply to the processor.
12 volts
The potential difference of 120 volts and 12 volts is 108 volts.
An ATX power supply unit delivers power in three voltages: 3.3 volts, 5 volts, and 12 volts. The 3.3 volt pins are used only in the motherboard connector. Older, AT power supplies and motherboards used only 5 volt and 12 volt pins in the motherboard connection.
No. 12 volts peak to peak would be 6 in the positive polarity and 6 negative polarity. Simply saying 12 volts AC would be 12 volts in each polarity or 24 volts peak to peak
If 12 volts is being applied to the starter and it will not function, then remove the starter and have it tested at an Auto Parts Store.
12 volts, 12 amps