answersLogoWhite

0

The purpse of valve lifters is exactly what it says, to lift the valve.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What are symptoms of bad valve lifter?

on a 98 ford taurus what are the symptoms of a bad hydralic valve lifter


Is there a difference on valve lifter valve intake and exhaust valve lifter on a 1998 Pontiac grandam 2.4?

The lifter's are all the SAME. the push rods are what is DIFFEERENT. Some are longer the the others. They MUST be put in the right place are you will bend a valve as soon as the engine turns over.


A lifter bucket on top of the valve stem and spring in an OHC engine helps to adjust the?

The lifter bucket, which is on top of the valve stem, and the spring in the Overhead Cam engine aides in adjusting the valve clearance.


What the function of valve spring?

It is to close the valve(keep it from bouncing/valve float)and keep the lifter on/followingthe cam. This is why race cams with radical lobes need 1000psi springs. The higher the rpm/ heavier the valvetrain the heavier the spring needed.


What is the function of lifter?

lifting somthing


Would a worn out lifter cause a taping in the engine or do you need to shim a valve spring?

It is cheaper than replacing the lifter


How many valve lifter use a 1996 camaro 3.8L?

12


What does it mean when there is a clicking sound coming from within the valve cover?

Valve lash needs adjusting or you have a lifter that is sticking.


How to tell if valve or lifter is bad in 2001 Chevy S10?

You can tell a bad valve by doing a compression test.


What type of valve lifter automatically compensates for the effects of engine temperature?

Roller


99 Z71 pickup with a 350 engine you have a lifter that is sticking how do you change them yourself?

take off the valve cover,remove the rockers,take off the intake manifold take out the push rods,then pull out the lifter,if the lifter is mushroomed you may need to get a lifter puller


Why would a 1992 2.5l 4-cylinder have a lifter or a valve tick after puting on a new head gasket only the 3 valve or lifter and its getting oil?

Need to readajust the lifters again first. That will fix it. the lifters are none adjutabil neather are the rocker arms the push rod is new and so is the lifter

Trending Questions
How do you adjust a transmission indicator switch on 2000 s10 blazer it will not shift out of 4 wheel low? How do you hook up your trailer lights to your 91 4runner? Why is the temperature gauge reading hot on a 2000 Chevy Impala? What is spark plug gap for 1998 F-150 4.6 V8? Where can you get a wiring diagram for a 1997 Geo Tracker so you can install a remote starter? 1998 Bonneville brake lightsparking lights stay on even after car is turned off? Where can one purchase a Firebird guitar? How do you change a fuel pump on a 1995 Mercury Villager? What will a flash of a 2001 impala ls computer do. i am trying to see if it will reset my air conditioner that is not blowing cold air. system works just no cold air.? How do you change a half shaft on 2004 ford escape? Wrangler SRA LT26575R18 recommende pressure? What is the difference between the Chevy 1500 and the s10? Why is car air conditioner not cooling or blowing really cold air? What is the engine oil capacity for a 2007 mustang gt? Can you reprogram an obd1 replacement pcm on a 1993 Jeep Grand Cherokee? Why does my steering wheel of my 99 Chevy Suburban jerk to the right or left when ever I am turning the wheel? How do you disable and remove the driver side airbag on a 1998 f150? How manyquarts of oil 2003 gmc envoy use? How do you replace a brake booster on a 1976 corvette? You are deciding between two cars with different engines and want the bigger of the two One engine displaces 350 cubic inches The other displaces 5500 cubic centimeters How many significant figure?