the function of an led is to give of light coming through an electrical circuit
lights up
requirements
Inductors
series
A fuse or a circuit breaker can be added directly after the power source (and possibly a transformer) to do this.
In almost any modern electronic device.
similarity between lamp and LED- lamp in simple current is used to show that current is flowing and LED performs the same task but in electronic circuit .difference between lamp and LED-lamp in simple current is used to show that current is flowing and LED performs the same task more efficiently but in electronic circuit . so LED works more efficiently in electronic circuit than lamp which performs task in simple circuit.
Its basically a rectifier circuit which converts A.C to D.C with a fixed voltage regulator. Apart from this it also has a LED that indicates the circuit is ON.
A circuit board consists of numerous electronic components, depending on the application, these components can be in the thousands or in the ten's, therefore circuit boards vary in numerous sizes, all connected using very fine electrical connection strands.
ntegratd circuit
to complete circuit
If a circuit requires an IR LED, it requires an IR LED, there is no replacement. If a circuit does not require an IR LED, there is no need to look for a replacement.
First you start with an idea of what the circuit will do.
write 3 components of an electronic circuit
write 3 components of an electronic circuit
An electronic circuit is a network of interconnected electronic components composed of one or more loops coupled that is designed to perform some useful function. The major difference between an electronic circuit and an electrical circuit is that the electronic circuit contains active components that can amplify and/or switch signals and/or nonlinear components that modify signal shapes, while electrical circuits contain only passive linear components in most cases.
If you are just using the load to pull a small amount of current, then yes a electronic circuit can be used for that. If you want a resistive load to measure voltage drop or something similar, then no an electronic circuit will usually not work for that.
something in a circuit