The bell housing surrounds the clutch assembly. Mounted between the engine and the transmission.
Clutch housing, torque converter housing
It is mounted to the clutch housing. Have someone push on the clutch pedal and follow the movement of the cable. From the driver side look down towars the clutch housing, it is on top.
First remove front axels, then remove the transmission, undo clutch bell housing. Add on new clutch pressure plate.....new clutch bell housing......put the transmission back in and axels
Absolutely!. If the rear seal on the crankshaft is leaking the oil from the engine can migrate to the bell housing and the clutch. It is also possible that the front seal on the transmission can leak and migrate to the clutch.
Don't know what kind of vehicle you have but a thermostat housing and the clutch are not connected in any way. Need more info.
The rods that go from the peddle through the firewall to the bell housing on the transmission to engage /disingage the clutch
The bell housing is the part of the transmission case that bolts to the engine. The bell housing contains the clutch or torque converter.
what is the job of a one-way clutch
The clutch and brake`s share the same resovoir the clutch master cylinder is attached to the top of clutch pedal and the clutch slave cylinder is inside the gearbox bell housing.
It is either worn out , glazed, or there is a fluid leak in the bell-housing , or clutch enclosure.
It is the part of the clutch hydraulic system that pushes on the pressure plate. It is normally located on or in the bell housing.