0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the reverse solenoid switch located on a 1997 Nissan Maximum?
The 1997 Nissan Maxima. Reverse solenoid switch is located on the starter. The solenoid switch is attached to the side of the starter.
Why does a 1996 Ford Ranger XLT 4.0L start when you cross the posts on its solenoid but not when you turn the key in the ignition?
the solenoid itself is probably bad, if not that probably the ignition switch I agree 100%, check the solenoid first then the switch.
Where is the solenoid switch on the jeep 2002 SUV?
The starter solenoid is on the starter. Transmission solenoid is in or on the transmission.
Where is the vacuum switch solenoid on your 2001 blazer It works with the air pump.?
The 2001 Chevy Blazer vacuum switch solenoid can be found on the firewall in the engine compartment. The vacuum switch solenoid will be on the passenger side of the firewall.
Where is the solenoid switch located on a 92 dodge ram van?
The starter solenoid is on the starter.The starter solenoid is on the starter.
What is a switch that begins with sole?
You have to be more specific to get the right answer
What is the function of solenoid valve in the air conditioner?
solenoid valve function is to hold or handle the flow of gas or liquid pressure
Why two solenoids for a 1977 Gran Marquis one on starter and one on firewall?
My '77 F250 also has two solenoids for the starter, one on the fender and the other on the starter. The one on the starter is the one you'd expect and has a mechanical function, it moves the starter gear to mesh with the ring gear on the flywheel to turn the engine over. The solendoid on the fender has an electrical function as a relay. A relay is basically a switch operated by another switch. In this case, the controlling switch is the ignition switch and the switch it operates is the solenoid. The current needed to operate the starter is so great that it would wear out your ignition switch plus require huge wires running from the battery to the dash so instead of switching this huge current, the ignition switch switches only the smaller current needed to operate the solenoid and the solenoid switches the huge current. When you turn the ignition switch on, it energizes the solenoid which closes the circuit that supplies current to the starter.
Why doesn't my 65 fairlane turn the motor with the switch I need to jump start from solenoid. I has new solenoid and switch.?
Did you replace the ignition switch? Not the key tumbler but the actual ignition switch. If so, you have a wiring problem.
Is it the starting motor or solenoid switch?
BOTH.
What is a switch to starter cable?
Starter solenoid?
Where is mountaineer reverse solenoid switch?
on the starter
