The stern tube in marine engineering allows the propellor shaft to penetrate the hull of a ship and prevent the ingress of water. It also acts as a bearing and lubricates that part of the shaft.
The propeller shaft in a boat engine is fastened to the flywheel by bolts, and it passes through the boat's thrust block and is aligned with the shaft tunnel. It also passes through the stern tube to drive the propeller. The stern tube shaft itself holds the "prop" shaft in place and shut off the open end when it pierces the aft hull. It is commonly manufactured as cast iron and welded into the frame of the stern of the ship.
The function of any ballast in a lighting fixture is to raise the voltage high enough to strike an arc through the bulb or tube.
The processor time is a function of the processor. The memory allocation is a function of the operating system.
state function did not depend on the path , it depends on the initial and final point of the system where as path function depends on the path of the reaction.
when the vacuum sucks up things it goes through the tube and into the bag ...Unless you are talking about electronics, then a vacuum tube is used to form an amplifying circuit. Some tubes can emit cathode rays onto a screen (Cathode Ray Tube = CRT) to display a picture and some can function as diodes to regulate current flow.
Oil lubricated and sea water lubricated stern tube
The fimbrae function to gather the released egg into the fallopian tube. From there, the egg travels to the uterus.
the function of draw tube is a ...............
a big ship
a big ship
the function of eustachin tube is to control the air pressure
The long tube
The propeller shaft in a boat engine is fastened to the flywheel by bolts, and it passes through the boat's thrust block and is aligned with the shaft tunnel. It also passes through the stern tube to drive the propeller. The stern tube shaft itself holds the "prop" shaft in place and shut off the open end when it pierces the aft hull. It is commonly manufactured as cast iron and welded into the frame of the stern of the ship.
A draft tube is used to transform water into energy. It is found in the piping system of jets, dams or anywhere turbines help with difficult mechanical work.
it is use to hold the test tube
it
it houses stern tube,give strength to aft portion,give profile to aft deep tank,support stringing member