0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where are the cylinder head casting numbers located for Chevy small block?
Under the valve cover where the valve springs are.
Do you take off the valve springs to get the head off?
No. The valve springs can remain on the head when removing the head.
What is meant by a valve spring compressor?
A valve spring compressor is used to remove collets in a car. The tool compresses the valve springs in the cylinder head of the car allowing the collets to be removed.
Is the intake or exhaust valve located in the cylinder head on a overhead valve engine?
Type your answer here... They are in the cylinder head.
The top of the cylinder head is sealed by the?
valve cover
What is the function of a spiral valve in a shark?
To get head
What is the engine upper end?
The cylinder head and valve gear.
How to compress valve springs?
If the head is still on the engine, you can purchase a kit at most auto parts stores that includes: an air fitting to keep the cylinder filled with compressed air to prevent the valve from dropping into the cylinder, and a special wrench to attach to the rocker stud and press down on the spring retainer while you remove the locks. If the head is off the engine, you will need a valve spring compressor, which is a large c-shaped tool that pushes on the valve's head on one end and the valve spring retainer on the other end. Also you can buy/rent a valve spring compressor that you can use while the head is still on the engine but you will still need to blow air into the cylinder through the spark plug hole to keep the valve up.
How do you replace valve seals on v8- 89 Chevy truck Ive heard stories of using air pressure to lift pistons and What is the difficulty?
First of all the air is for holding the VALVES up in the head so they don't fall down into the cylinders when you take the valve springs off of the valves. You should have a trained mechanic do that job for you. If the valve falls out of the head then you will have to remove the cylinder head to get it out.
Is a valve gasket and a head gasket the same thing?
Valve cover gasket holds oil from the valves from leaking off the top of the head . Head gasket is lower and holds cylinder pressure between the cylinder head and the engine block.
Where is the intake valve on a 2000 Olsmobile Alero?
There is one intake valve for each cylinder. It is located in the top of the head. If you remove the valve cover, you can see the stem of the valves by peeking through the caps in the valve spring. If you want to replace a valve, it will be necessary to first remove the cylinder head.
What are the torque settings for Nissan Patrol 4.2 diesel cylinder head and valve clearances?
What are the torque settings for Nissan ZD 3 liter turbo diesel cylinder head and valve clearances?
