in parallel circuit voltage remains same ..... so all the appliances run at their rated voltages without having any problem as real power supplied depends on voltage .... p=(v^2)/R
When capacitors are connected in parallel, you add up their capacitances to obtain the overall capacitance of that 'bank'. The main reason for using two capacitors in parallel when decoupling, is that they have a lower overall inductance (electrical resistance in essence) to one large capacitor, which improves the decoupling effect. Using two capacitors also provides better high-frequency filtering for the power bus. One minor advantage of this, is that, you can obtain a certain redundancy when using two smaller capacitors in parallel, instead of only one, as if one capacitor fails, the other still acts to decouple the circuit, to a certain extent. Source: http://www.cvel.clemson.edu/emc/tutorials/Decoupling/decoupling01.html (this article uses other sources to back up their statements)
What is the advantage of using an PLM
It is called an open, incomplete, or broken circuit. Circuits might be opened intentionally (using a switch), or unintentionally (breaks in, or disconnected wiring).
parallel connected and series connected circuits.AnswerIn terms of connections, there are, in fact, four types of circuit. These are:seriesparallelseries-parallelcomplex'Complex' circuits are circuits that do not fall into one of the other three classifications, e.g. bridge circuits, and which can be solved using circuit theorems, such as Thevenin's, Norton's, etc.
A parallel circuit
They last longer than series circuits.
Using a parallel circuit energy can be transferred through a parallel circuit.
My house is wired using parallel circuits. How did they wire yours?
So you don't have to turn on all the lights at the same time.
It makes the calculation of currents and voltages easier.
20
Advantages in electric circuits : Advantages of using the rheostat in electric circuits is optional as you could just use the dial on the power-supply to vary the voltage (p.d.), and therefore the current. The advantage of using the rheostat is that you can control it to give you nice even numbers for the voltage.
When capacitors are connected in parallel, you add up their capacitances to obtain the overall capacitance of that 'bank'. The main reason for using two capacitors in parallel when decoupling, is that they have a lower overall inductance (electrical resistance in essence) to one large capacitor, which improves the decoupling effect. Using two capacitors also provides better high-frequency filtering for the power bus. One minor advantage of this, is that, you can obtain a certain redundancy when using two smaller capacitors in parallel, instead of only one, as if one capacitor fails, the other still acts to decouple the circuit, to a certain extent. Source: http://www.cvel.clemson.edu/emc/tutorials/Decoupling/decoupling01.html (this article uses other sources to back up their statements)
no only series and parallelcircuitAnswerThere are four categories of circuit: series, parallel, series-parallel, and complex. 'Complex circuits' are not necessarily complicated (although they very often are); the term simply describes any circuit (e.g. bridge circuits) that doesn't fall into any of the first three categories and which need to be solved using network theorems.
Its advantage is that it is a great product, and disadvantage is that it is a fertilizer.
Copper is : a good conductor, easy to work, and relatively cheap. And you use the insulation to help avoid shorts.
In a circuit with many devices in series, if any one single device isturned off, unplugged, or burns out, then ALL of the devices lose power.That would be very inconvenient in a building.