I am searching for same info for 1999. The 15mm bolts seem to be 11mm thread with a fine thread of 1.5 or 1.25.... or 1? looking to Ford... then my local machine shop. good luck
The 2001 Ford Windstar has the ( 3.8 liter ) over head valve / pushrod V6 engine
The Ford 3.0 liter cylinder head bolt torque specification is 150 pounds. The cylinder head bolts should be torqued in 50?æpound intervals.
on my windstar speedo only worked when it wanted to I replaced the speedo head 2 years later still works great
either a blown head gasket or cracked cylinder head
On a 1998 Ford Windstar : Both the 3.0 and 3.8 liter V6 engines are Over Head Valve / pushrod design engines and each have ( 1 ) timing CHAIN
This would be a primary symptom of a blown head-gasket.
if alloy head 40nm then tighten 90 degrees
The 1990 Ford Festiva 1.3 liter engine cylinder head bolt torque specification is 125 pounds. The cylinder head bolts should be torqued in 25 pound intervals.
Which motor?the 3.0 is 95lbs.
torque for 97 taurus head
where is the CHT sensor on a 2000 ford F150 where is the CHT sensor on a 2000 ford F150
No - the head gasket repair can be done with the engine still in the vehicle.See "Related Questions" below for more