Want this question answered?
The water pressure increases with depth, thus water comes in faster through a hole the deeper it is.
This hole is most likely to allow air to escape from the back of the speaker, allowing the speaker cone to vibrate more freely.
a little hole in the back pushes out air while the bottom of the vacuum sucks in the dust or whatever your vacuuming
343m/s x 5.71s = 1958.53m, less the distance from the level of the hole's opening to the spelunder's ear.
A keyhole looks black because there is no source of light inside the keyhole, and very little light gets into the hole from outside to illuminate it. Just as the bottom of the ocean, when you have no source of light, appears black to the human eye, until you use some source of light.
theres a hole in the bottom of the sea theres a hole in the bottom of the sea theres a hole theres a hole theres a hole in the bottom of the sea
A is the first two holes on the top covered and the bottom hole covered. B is the first hole on the top and on the bottom. C is the second hole ( not the first hole ) and the bottom hole.
With the lock mechanism missing, look into the hole where the lock should be. Take a flat screw driver and insert it into the slot near the back of the lock hole and twist.
if there is not a key hole you cannot lock it.
What's the formula to calculate bottom hole pressure
A hole for inserting a key in a lock.
there should be two hole near the bottom of dipstick if the oil is at the top of the second hole from the bottom its full if its at the bottom hole its a quart low
If by "bottom hole" you mean the round hole at the end, then no. Most of the sound of a flute comes out near where the mouthpiece is
A mechanical problem is causing your Ford Explorer not to lock with the bottom when your start the car.
Bottom hole Temperature is 85F + (0.015 x Depth in feet)
Check to see if there is a small hole in the bottom of your steering column cover , if there is rotate your ignition lock cylinder to the run position and push a small punch ( or something that will fit through the hole ) to press the release
you will either have a hatch mark or a hole drilled in the dipstick if you have the hatch mark then at the bottom of the mark if a hole then the bottom hole