0
Usually 4,2 or 4,5mm.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What size hole needs to be drilled for a 0.375 screw?
You want a .375 hole. +.001, -.001, maybe.
What size screws are required to mount vizio e260mv flat panel?
Vizio doesn't make a E260MV model, but they do make a E260VA. They use a 10mm M4 screw (metric 4mm diameter, 10mm long). The VESA hole pattern is 100mm x 100mm.
Does hitting a pot hole screw up your rims?
Might do. Depends on the size of the pot hole, your tires and on how fast/hard you hit it.
Why do gunsmiths drill screw holes slightly under the minor size of the screw tap before using the tap?
The hole would have no metal to cut the threads in if the hole were drilled the same diameter as the tap.
What size drill for 12 metal screw?
If you want it to grip, drill a 9/64 hole. For a clearance hole, drill 7/32.
When removing screws while working on a laptop what should be done with the screws?
Put screws (and other parts) in a safe tray or container so they won't roll away, blow away, get lost.Keep track of which size screw came from which screw hole so you don't put it into the wrong size hole leaving a loose screw or a stripped plastic screw hole.It may even be a good idea to keep track of where each screw came from as some screws are very close in size.
What size drill bit for 10 metal screw?
It really depends on the material you are drilling. Thinner material will use a smaller pre-drill bit. Try drilling a sample hole on a piece of scrap or where it will not be visible Then try your screw. Adjust your hole size if necessary
How do you put a wood screw in a hole that the screw just spins?
by makin a new hole
What drill bit size for a 832 screw?
That size is 8-32. The drill bit for a clearance hole is 11/64, or a #17 drill bit.
What tools would you use to make a screw hole?
If you don't want to bother getting your electric drill out just to make a starter hole for a screwfew/a screws you could use one of two small hand tools. A. a bradawl which is a small tool.like a small screwdriver but with a pointed end B a gimlet/twist gimlet which is a T-shaped tool that you twist into wood to make a hole (it resembles a small corkscrew)
What size pilot hole do you drill before using the countersink bit in stainless steel?
I drill a pilot hole the size of the 'barrel' of the screw. -I always use a combination drill bit for sinking screwheads. The first part of the bit is the diameter of the 'barrel' of the screw and the step, one inch higher is the size of that screw's head. (The barrel is the diameter inside threads) -I have a set of these drill bits for #6, #8, and #10 screws and they are great.
What is the area called that the screw goes into The part with the ribs like that you screw the screw down into...?
The hole that you put a screw into is referred to as a "tapped hole". The rib-like things in the hole are called "threads" or, more specifically, "internal threads" as opposed to the external threads on a screw.
