THE ICP SENSOR IS A SENSOR THAT READS THE PRESSURE, IN THE HIGH PRESSURE OIL SYSTEM, & SENDS VOLTAGE BACK TO THE ECM IN ORDER TO DETERMINE WHEN TO FIRE THE INJECTORS BASED ON THE VOLTAGE THAT THE ECM RECIEVES. The ICP sensor's primary function is to provide a feedback signal to indicate injection control pressure to enable the PCM to command the correct injector timing and pulse width and the correct injection control pressure for proper fuel delivery at all speed and load conditions.msc
The icp sensor on an 05 powerstroke is on the passenger side valve cover towards the front of the engine
i want to know were the icp censor on a 1995 f 350 its located
It is located in the valve cover on the passenger side of your vehicle. It will have a small wiring harness plugged into it. It is a small sensor, but very easy to access on the 2006.
cam sensor or icp sensor!!
"Ford ICP" stands for "injector control pressure"
there is a plug with 3 wires comming out of it plugged into the ICP located on the driver side of the engine right above the #2 cylinder on the head (the inside part of the V), if the wires are soft as they usually are, you need to replace the ICP and have a new plug installed on it. OIL gets in there and messes it up.
I believe you mean ICP Injector control Pressure sensor. If so its located behind the turbo charger next to the IPR sensor You can access the sensor by removing the rear heat shield from under the vehicle. Once removed you can see the sensor and connector. Heat shield is held on with one 13mm bolt and two 10mm bolts. ICP sensors were known to leak oil and ford recommends replacing the pig-tail harness also. Ford reliazed this and moved the sensor to the right valve cover in 2004.
its located on the back part of the diesel filter housing on top of the engine.
the ICP is located between the drivers side valve cover and the fuel bowl a small round plug with 3 wires. on top front of the motor.
have to remove the turbo. absolutely insane. i am getting read to change mine in the next few days
my poo is your mum.
ICP= injection control pressure, it senses the high pressure oil and reports it to the computer to determine fuel control. It is located on the back center of the valley of the engine on the high pressure pump cover.