21t
Steel sandwich plate. 5 speed count splines on input shaft
Saves input shaft spline
The input and output shafts need to be marked Then put in a particular gear Rotate the input shaft ten revolutions and count the output shaft revolutions. Or read the specs in the manual OR disassemble the trans and count the gear teeth.
the input shaft has splines on it which connect to the clutch friction plate.
It is the number of rotations of the input shaft to the gearbox as compared to the number of rotations of the output shaft from the gearbox. The ratio will change each time a different gear is selected.
The parts will only work if you use an oil pump that goes with the chosen shaft. In other words, one must use a 27 spline shaft with a pump made for 27 splines. And to use a 30 spline pump you must use pump made for 30 spline shaft. Then you run into the complication of 30 spline pumps are made for 1987 and newer transmissions which have an auxilary valve attached to the valve body surface. So you now have to go out an buy a 87 or newer trans case. Meanwhile the dollars are flying out of your wallet. Finally the torque converter is also matched to the input shaft. So to make a long story short. If you have a 82- 86 700r4 with a 27 spline shaft keep it the same, or if you 87 or newer 700r4 has a 30 spline shaft keep it.
A 1994 uses a New Process 241C with a driverside output and a 27 spline input.
Toyota sienna radios have the aux or disc button on the radio, they also have the plug for the auxiliary audio input interface behind the Toyota radio but it is not in the vehicle the audio input interface needs to install into the vehicle, depending on the year of your vehicle if older you need the toy-aux or if newer Toyota you will need the toy03-aux this are the Toyota audio input interface part numbers, or you can go to yahoo search and look for ( Toyota auxiliary input )
A spigot shaft is also known as a primary shaft or an input shaft in an automotive gearbox. It protrudes from the gearbox into the bell housing and connects the clutch plate to the transmission.
front transmition shaft Input Shaft
It will be due to the input shaft bearing in gearbox.
A sliding mesh gearbox is a piece of equipment used to change the gearing ratio between an input and output. They allow the ratio to be quickly changed on the fly for optimal efficiency.