Saves input shaft spline
180 torque lbs too much and you F up the hub Bearing BE CAREFUL !! PS when sliding the 1/2 shaft spline in the bearing It is best to FREEZE the SPLINE in the refrigerator this shrinks the spline and slides in MUCH BETTER DO NOT BEAT IT IN !! you can damage the bearing like that !!
you have to take all brakes and rotor off the hub. then you must spin the hub so the access hole is in front of the bolts,and take all 3 bolts off. then you must pull the hub off of the spline.
the purpose of the spline is to support the weight of your head
It will either be a 28 or 31 spline. I believe that most open rear ends used 28 spline and the limited slip rear ends used 31 spline.
spline (= groove) = ranura (noun), ranurar (verb)
In the mathematical subfield of numerical analysis, a spline curve is a curved defined polynomials portions. A spline can also be a portion of wood or metal.
Spline goes into transmission or transfer case.
maa ka lauda
no.
No you can not live without a spline. If you mean spleen, yes you can live with out it. If you mean spine, no.
Smooth curves
im pretty sure the spline count depends on the year the tranny is