upper plenum torque is: 44in lbs first time around89 in lbs second time aroundThe lower intake manifold is: 27 in lbs first time around 106in lbs second time around133 in lbs third and final torqueuse a good torque wrench and follow the tightening sequence. If you skip a torqueand go to the last the chances of gasket damage can result. If you did not have to remove the upper plenum assy then follow the lower torque sequence only. Also add a good RTV sealant around the coolant ports on both heads and gaskets. If the formed segment gaskets are too hard to manage use Black RTV on both ends of the block where the manifold sits flush with the front and rear. This is a 100% seal every time.
What are the intake manifold torque specs on 1998 Oldsmobile bravada?"
The 1997 Mercury Cougar 4.6 liter engine intake manifold torque sequence should begin at each end of the manifold. Keep moving towards the center and alternating from and to end.
Yes it does.
30 ft-lbs
The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.
step 1; 26 in-lb, step 2; 106 in-lb, step 3; 132 in-lb
the haynes book states 89 in pounds
Assuming this is a 4.3L engine, the fuel pressure regulator is located under the upper intake manifold. The upper intake manifold must be removed to gain access to the regulator.
It is located under the upper intake manifold and is attached to the bank of injector poppets, aka the "spider". The upper intake manifold has to be removed to gain access to the regulator.
The lower intake manifold to cylinder head torque specification is 132 inch pounds. The upper plastic intake plenum to lower intake should be done in three steps 22 inch pounds, 44 inch pounds and thirdly 89 inch pounds. Be sure to follow the appropriate tightening sequence diagram.
torque specs are lower intake 115in-ibs upper intake 18ft-lbs
It is on the firewall end of the intake manifold below the distributor