No load is the least destructive load to a switch.
Resistive loads
On load switching is when a switch can be operated whilst current is still passing through the switch (i.e. it is on load) Offload switching is when a switch is operated whilst there is no current through the switch (i.e. it is offload)
Isolation switches can be closed with loads connected. The isolation switch should not be opened under load unless the switch is load rated. This information can be found on the isolation switch's cover as to the amount of current that can be safely interrupted.
A switch is a non automatic mechanical device capable of opening or closing a circuit under normal load conditions
A relay is basically a controllable switch that connects a supply voltage to a load. If the relay is switch such that the load is not connected, that could be considered an open load. If it is switched the other way the load will be connected to its supply voltage. A defect in a relay would be something that caused it not to function correctly. It could be in the switch portion of the supply portion of the relay. Hence you are referring to different things and a defect may or may not cause the load to be open.
Both are types of isolators of a power circuit. Load break switch is an isolator where circuit can be isolated on load. The quenching media could be air, oil or gas..... Air break switch is type isolator where isolation takes place in the air itself. (break contacts are not immersed in oil, gas ...) But whether these isolators can be opened on load or not can be said only by looking at the desgin data. Some isolators are designed to open and close on load.
On load switching is when a switch can be operated whilst current is still passing through the switch (i.e. it is on load) Offload switching is when a switch is operated whilst there is no current through the switch (i.e. it is offload)
When eruption types are arranged from most destructive to least, it is in descending order.
When eruption types are arranged from most destructive to least, it is in descending order.
When eruption types are arranged from most destructive to least, it is in descending order.
PlinianVulcanianStrombolianFissure
This is what the purpose of a switch is. It connects the "hot" wire to the load. When this is done the load becomes energized.
The least destructive method would be to simply identify the desired mineral specimen by eye and pick it up.
No it is not considered a load. A load transforms electrical energy into other types of energy :)
The switch to load the radio with comsec should be located on the radio itself. It may be a physical switch or button that needs to be activated to enable the comsec loading process.
The load will be zero after the switch is turned off. if power is still being drawn then the switch is quite likely faulty
No it is not considered a load. A load transforms electrical energy into other types of energy :)
It is the terminology given to differentiate the dimmer switch from a three way dimmer switch. It is a replacement for an ordinary lighting load switch when you want to dim the lighting load for aesthetic value.