0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Need to change the timing belt on 2001 Mitsubishi Montero Sport?
who do you set a timing on a 2001 Mitsubishi montero
How open door without key on Montero sport?
How do you unlock door of 2001 Mitsubishi montero sport without a key
Where is the Manifold differential pressure sensor 2001 Mitsubishi Montero Sport?
manifold differential pressure sensor montero sport 3.0
Where is the fuel injectors located on a 2001 Mitsubishi montero sport?
The fuel injectors on a 2001 Mitsubishi Montero Sport are located on the top, back side of the engine. They connect directly to the cylinder and provide fuel for combustion.
Where is the Manifold differential pressure sensor 2001 Mitsubishi montero?
manifold differential pressure sensor montero sport 3.0
What size are 2001 Mitsubishi montero sport speakers?
6.5 in the door 4 in the dash
2001 Mitsubishi montero limited burning rubber smell?
my 2001 mitsubushi montero sport sometimes smell like burning rubber what could it be coming from
How do you find a diagram showing 2001 montero serpentine belt installation?
where can you find a free diagram for putting a air conditioning belt on a 2001 Montero sport Mitsubishi?
How do you get the starter on a 2001 montero sport out?
how do you replace the starter on a 2001 montero sport?
Where is the alternator on a 2000 Mitsubishi Montero Sport?
If it's the same 3.0L engine they put in the 2001 Montero Sport, the alternator is (looking from the front of the engine into the bay) located on the left side of the motor, toward the radiator, down low. It's straight below the power steering pump. There should be a belt that runs from the crankshaft to the alternator. Good luck... I'm on my third in 3 months.
How many miles do you have left once your gas light comes on a 2001 Mitsubishi Montero sport?
about 7 feet.
What are the valve cover torque specs for a 2001 3.0 Mitsubishi Montero Sport?
The 2001 Mitsubishi Montero Sport 3.0 liter engine valve cover torque specification is 40 pounds. You do not want to over torque the valve cover bolts, as you may ruin the valve cover gasket.
