Intakes can be plastic, aluminium, or iron (steel). Exhaust manifolds are always steel or cast iron.
The intake manifold is where the air and fuel mix and enter the engine. The exhaust manifold is where unspent gas and air exit the engine. In other words the intake manifold is where the engine breathes in and the exhaust manifold is how the engine exhales out.
Intake manifold delivers the fuel air mixture to the cylinder heads, exhaust manifold collects the gases after combustion, and channels them into the exhaust pipe.
On every vehicle there are two manifolds. An intake manifold and a exhaust manifold. The intake supplies fuel and air to the cylinders. The exhaust collects exhaust from those same cylinders.
remove the intake and exhaust manifolds. there are bolts that attach them onto the head and there are bolts near the carburetor that attach the intake manifold to the exhaust manifold.
Depends on which one, there is an intake manifold and an exhaust manifold. The intake(normally aspirated)- you have to remove the air intake tube, throttle body, disconnect sensor, injector wires/vacuum hoses. Disconnect the fuel line to fuel rail, then you can unbolt the intake manifold. The exhaust manifold- is a little hard being against the firewall, you would have to disconnect the O2 sensor wires and exhaust pipe. I would spray the exhaust studs with penetrating lube. The upper nuts you should be able to get from the top, the bottom nuts you will need to get to from under the vehicle with a swivel and extentions.
it is located right in front of the car behind the fan.THAT'S THE EXHAUST MANIFOLD, THE INTAKE MANIFOLD IS ON THE *..BACK..* OF THE ENGINE. FOLLOW THE AIR INTAKE.
Carry away exhaust gases from the engine. Intake carries a/f mix to cylinders.
Intake Manifold 140557055 is for a 283 SB Chevy.
Intake manifold on top and exhaust manifold on the side.
look at the head with the valve cover off find where the exhaust manifold goes in tha is the exhaust valve or looking at the valves the first one is exhaust then intake then intake ,exhaust,exhaust,intake,intake,exhaust if you have the head off i think the intake valves are bigger than the exhaust
the exhaust side is by the exhaust manifold,intake side is next to fuel injectors.
No. It is located on the exhaust path.