Want this question answered?
1000baseLX is a fiber optic standard for gigabit transmission. It can be up to 5 km using SMF fiber. MMF fiber will allow a maximum segment length of 550 meters.nodes per cable segament
MM fiber is multi mode fiber.strength 1.more (fiber area cross section) light carry componet core is 62.5 microns2. Same cable can be used for both single mode and multimode transmission.weakness is less transmission distance 2kms (half of the single mode fiber distance)
That depends on the mode on the fiber,Multi or single mode,also depends on your routers and distance from orignal signal.lots of variables.
The distance is about 100 for both CAT-5e and CAT-6. One of solutions is to install replicator, another one is to use coax either thinnet (175 m) or thicknet (400 m). Also you can use fiber optices (if you are going to use with long distances single mode fiber has to be used).
The maximum speed Ethernet of mm fiber has a transmission speed of 100 Mbit/s. The Ethernet mm fiber increases the speed from 10 to 100 megabits per second.
Depends on the equipment. Common enterprise grade equipment can transmit up to 10Gb/s of data over a distance of up to 10Km. Since you need 2 strands of fiber it would be 10Gb of data in full duplex (or 20Gb real throughput) I would guess some special telecom equipment can go faster but nothing Ive ever looked at goes over 10Gb The big difference between single-mode and multi-mode fiber is single-mode has a longer range because it is build to a higher specification. A poor comparison would be Multi-mode is like cat 5 and single-mode is like cat 6
Multimode; "Single-mode fiber gives you a higher transmission rate and up to 50 times more distance than multimode, but it also costs more."
rice and tuer dal has max fiber which is maximum abosrber.
SM=single mode,LX shown distance of transfer that is over than 4km for LX.
SR (Short hul) is a multimode fiber while LR (Long hul) is a single mode fiber, the SR spans much shorter distance than the LR
100000mbps
Single Mode cable is a single stand (most applications use 2 fibers) of glass fiber with a diameter of 8.3 to 10 microns that has one mode of transmission. Single Mode Fiber with a relatively narrow diameter, through which only one mode will propagate typically 1310 or 1550nm. Carries higher bandwidth than multimode fiber, but requires a light source with a narrow spectral width. Synonyms mono-mode optical fiber, single-mode fiber, single-mode optical waveguide, uni-mode fiber.