Depend on what is the Horse Power of the split unit. For Example 1Hp split unit can go up to 0.2 refrigerant ton maximum.
http://weightlosstreatnow.com
If you have a split unit - one with an outdoor condensing unit and an evaporator coil built into the furnace indoors, the refrigerant type will be shown on a label or engraved metal plate attached to the condensing unit. The amount of refrigerant will vary, depending on the diameter and length of pipe connecting the two units. Most window air conditioners have an hermetically sealed refrigerant loop and cannot be recharged in the field, although they may also list the refrigerant type on a data plate somewhere.
The refrigerant pressures are dependent on the type of refrigerant.
It has to do with the type of refrigerant that the AC unit needs to be recharged with.
A 2001uses R134a refrigerant.
That would depend on the type of refrigerant that is being used.
R-134A. DuPont was the originator of this refrigerant (not Freon) and they called it Suva 134A.
A Goodman GSH13601AB is a split heat pump condensing unit. This unit requires R-22 refrigerant (freon). No, an oil trap is not required however an inverted refrigerant trap is required at the indoor unit. Refer to Goodman Technical Publicatin TP-107 for detailed instructions for Long Line Set Applications.
More than likely R134a. It should be listed somewhere on the A/C unit.
They use R410a eco friendly refrigerant gas now.
actually for the a/c have 2 units,one is the indoor unit and the other is the outdoor unit, and there will be a refrigerant gas flowing in between the two units (in the copper pipes) when the refrigerant comes to the indoor unit it comes with a cold format .and when the chilled refrigerant comes in the way of the hot air ,the refrigerant becomes hot and the air becomes cool. (there will be a blower inside the indoor unit to blow the air across the refrigerant pipe's and hot refrigerant now goes to the outdoor unit (i.e condenser), where the outside atmosphere air comes across the hot refrigerant so that the hot refrigerant becomes cool and the cold air becomes hot. so, the indoor unit is maintained in a cool temperature and the outside outdoor unit is maintained at a hotter temperature.
Is it a new or an old window unit? Assuming your looking to refill it I will assume it is an old window unit which most likely uses R-22 refrigerant. R-22 is an ozone depleting refrigerant that is being phased out but should be available until 2010. There should be a label on the window unit stating which refrigerant is used.
I have a 99 durango and the amount of refrigerant needed for the single unit and double unit are listed under the hood on top of the radiator.