Want this question answered?
Stereo codes are unique to each stereo and you will have to get the serial number from the stereo and call an Acura dealer for the code.
On a Peugeot 806 car stereo there are two thin pieces of black plastic at each side, you need to gently prize them off, and that reveals 2 screws on each side you can then remove the stereo. -Jakey5565
This rule applies to material that you show to your audience while giving a talk. Your presentation shall not distract from your talk, therefore only the main keywords shall be shown. Otherwise people end up in reading your presentation slides instead of listening to what you say.
go to walmart in the auto stereo section they sell the tools to pull out the factory stereo on ford .the 2 tools that are shaped like big (U) . one for each side of stereo
You can get a Ford Fiesta stereo wiring diagram at a website called modifiedlife. It also lists all the wire colors for each component that is needed for wiring the stereo.
What is the maximum each pallet can weigh in a 22 pallet load when the maximum weight allowed is 45,000 lbs
u need a stereo pulling tool. you can get it at any auto parts store just ask and they will tell what kind to buy. there should be two holes on either side of the stereo u just insert the tool, and pull the stereo out. You don't need a stereo puller if you have a thick wire hanger. Cut the straight parts of the hanger with snips into 2 lengths, each about 6 inches long. Bend each into a "U" shape so that both ends will fit into the holes on the stereo. Insert both "U's" into the four holes on either side of the stereo and simultaneously pull each to the side so that the wire will compress the spring locks that hold the stereo in place. Once you have a good grip with each U against the stereo, slowly start pulling it out while keeping the pressure on. You may have to wiggle it a bit to get it started. Save the ten bucks a stereo puller will cost.
A home stereo depreciates by 20% each year. What's the value of a stereo, purchased new for $1,200, after two years?
You can find the wiring diagram for the stereo of a 1998 Volkswagen Passat in the service manual. It shows what each color wire is used to connect each component and where the wire is routed.
as far as getting the stereo out, you need to buy "keys" that slide in vertically on each side of the stereo. you can get the "keys" on eBay at a reasonable price. im not sure what the wiring is like on the back side. hope this helps.
How about a audio cable with two MALE RCA jacks on each end. If both units are not stereo, use a "Y" cord to convert stereo to mono.
It is part of the hazard switch under the stereo (go figure). Push the side clips in on the stereo in and they will pop out giving you a little handle on each side. Pull both handles and the stereo will slide out. On the floor of the opening for the stereo there is a hole which you can see the back end of the flasher switch. Push it forward with your finger and it should pop right out. At least for me both the stereo and flasher came right out in about 10 seconds. It is part of the hazard switch under the stereo (go figure). Push the side clips on the stereo in and they will pop out giving you a little handle on each side. Pull both handles and the stereo will slide out. On the floor of the opening for the stereo there is a hole which you can see the back end of the flasher switch. Push it forward with your finger and it should pop right out. At least for me both the stereo and flasher came right out in about 10 seconds.