No. The coarse thread UNC screws will not thread into the fine thread UNF holes. UNC must be used with UNC and UNF with UNF.
unc is coarse, unf is fine pitch
It is the angle between the cutting edges.It is usually 118 degrees
Hss drill bits, Titanium coated drill bits and brad point drill bits.
A titanium or cobalt drill bit.
I would use an 18mm or 23/32 drill bit, in general, although it does partly depend on the thread type ( UNF, UNC etc) and the material .
UNF refers to UnNormalised Form.
No. The coarse thread UNC screws will not thread into the fine thread UNF holes. UNC must be used with UNC and UNF with UNF.
VSR - acronym meaning Variable Speed Reversible drill
No.
unc is coarse, unf is fine pitch
As of July 2014, the market cap for Unifirst Corporation (UNF) is $2,021,434,001.94.
Portable and electric are adjectives describing the drill, a device for boring holes.
There does not seem to be a phrase "donkey drill" anywhere online. Perhaps it is a regional saying in your area.
variable speed drill No. The correct answer is: Variable Speed Reversing, meaning it has a switch that lets you run the drill clockwise or counterclockwise, at any speed from 0 RPM to the maximum rated speed for the drill in question.
A 12v Mini Drill is just a small drill with a 12 volt power supply. This can either be with an a/c adapter or rechargeable 12 volt battery.
Universal Noise of F***ing