Forged steel
silver metal
no, if you are talking about the original k18 the k18 2 came out and is used on a straight shaft
A Crank Shaft Position Sensor is a magnetic sensor that determines the position of the engine's crankshaft. It is used to set the electronic timing for the car's computer, so it is a very important part of the electronics.
Engines supply energy the an engine shaft(metal cylinder) by making it turn. We used engines for almost everything... Cars, planes, fans.
A hoe is a simple agricultural implement consisting of a shaft to which a thin broad metal plate is affixed at a right angle. It differs from a spade which has a metal plate fixed in line with the shaft. A hoe is used for breaking up the soil, for making furrows, and for weeding. The typical motion of hoeing is a chopping motion. A similar tool is the adze, which is used for shaping wood.
It turns the balance shaft. The balance shaft helps reduce vibration in the motor. It is usually driven by a belt that is connected from the balance shaft to the crank shaft and a tention adjusting wheel used to apply tension to the belt. Hope this helps, Dirk.
It could be steel, brass, stainless or other corrosion resistant material
There is not 1 on that year. They were NOT used untill 1996
Heavy metal!!
copper metal is ussualy used for making pipes
Crank pulley Piston connects to the crank shaft. One side of the crank shaft connects to the transmission and the other side connects to the crank pulley. It serves two main purpose. First one is it is used to time the engine (marks etched into it by manufacture) the other is to power other devices such as the alternator or power steering via a belt system (older cars used chain and gear sys). It is usually found closes to the bottom of the engine at the front, just follow the belts to the bottom.
The metal is Tungsten.