0
What is the method of supplying water drop by drop to the plants?
Wiki User
∙ 8y ago
This is an economical and modern method of irrigation in agriculture.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How do bees help plants?
Bees help plants by getting nectar from flowers. By getting nectar, they have pollen stuck to their bodies, and by flying around, they drop the pollen to plants, who uses it to flower and as fertilizer.
Will voltage drop over cable distance?
If the voltage is supplying any current through the cable, i.e. if there is any 'load' at the end, then the voltage will drop through the cable.
What Key Do You Press to Copy data using the drop and drop method?
ctrl
What is drip irrigation?
Drip irrigation is a form of irrigation where water is literally applied as drops to each plant from a dripper attached to a plastic pipe This form of irrigation can be very helpful on undulating land, and uses limited water supply to its best advantage.Drip irrigation is also called trickle irrigation and it is the best method of irrigation because, by the falling of water drop by drop into the roots, the water does not get wasted.It is also known as micro-irrigation.In this system water falls drop by drop just as the root zone.This system minimizes the use of water and fertilizers by allowing water to drip slowly to the roots of plants, either onto the soil surface or directly onto the root zone through a network of valves, pipes, tubes and emitters.
Dose every water drop follow the same path?
It can and it sometimes it can't. It depends if the water drop was close to it. If was close to it the water drop would attrack the next water drop you drop
How do you get rid of cutworms?
Cutworms can quickly eat their way through your favorite plants. To get rid of them, spray your plants with insecticide or pick the worms off and drop them in a bucket of soapy water to drown.
What does rain do?
Well it just doesn't because how can water affect water. For if you didn't know rain is water
What are the differences between emf and voltage drop?
emf and voltageAnswerElectromotive force is the potential difference created by a source, such as a battery or generator, when it is not connected to a load -in other words, on 'open circuit'.Voltage drop is the potential difference across a load, such as a resistor, which causes current to flow through that load.A voltage drop occurs, internally, in batteries and generators, when they are supplying a load. The battery or generator's terminal voltage, when supplying a load, is its e.m.f. less its internal voltage drop.
Is a drop of blood same size af a drop of water?
No it is not, a drop of blood is smaller than a drop of water but if you drop two drops of blood then that equals the right amount of water :)
When was A Drop of Water created?
A Drop of Water was created in 1987.
What is the correct wire size to install with a distance of 200 feet for a 100 amp single phase underground service?
This is a voltage drop question. A #1 copper conductor will limit the voltage drop to 3% or less when supplying 100 amps for 200 feet on a 240 volt system. Or a 3/0 copper conductor will limit the voltage drop to 3% or less when supplying 100 amps for 200 feet on a 120 volt system. In your question you sis not stipulate what the working voltage is.
What is the silver line in hanging drop method?
The sliver line that you see is actually an artifact and the edge of the drop.
