answersLogoWhite

0


Best Answer

30 inches

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the minimum allowable side distance from 480 volt electrical panel and emergency safety shower?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the minimum allowable voltage during load of 70 degrees Celsius?

There is no minimum


What is meant by minimum electrical clearance?

The minimum electrical clearance is the minimum distance between electrical conductors with different potentials (voltage). This generaly determined by the maximum possible voltage differenge between the conductors. Dimensions larger then the minimum electrical clearance are OK, however smaller dimensions start to risk arc-over between your conductors.


What is the minimum percentage allowable for brake pads on a tcuv?

75%


What is minimum efficiency for gas fired forced air furnaces?

Currently the minimum allowable for sale is 80%.


What is the minimum allowable brake accumulator pressure required for tow?

3000 PSI


What is the minimum allowable grade on a 4in sewer pipe?

1% pitch is min


The minimum distance between the declination station and such objects as power lines and electrical equipment is?

Power lines and electronic equipment: 150m


How far does separating plumbing pipes and electrical wiring?

Whether the pipes and wiring are chased or not. A minimum distance of 200mm is recommended. Making sure that the water pipes are always underneath the electrical wiring.


What was the minimum allowable width of bikinis at Bondi Beach in 1961?

Type your answer here..5 inches


What is the minimum distance between the instrument control cables and the electrical power 220 VAC cables run in the same cable tray?

0.5 Metres roughly


What is the minimum allowable interest rate on a promissory note between two private parties in the state of Florida?

Minimum interest upon promissory note in wisconsin Loo


What is the minimum allowed flash point for fuels on board naval vessels?

The minimum allowable flash point for all fuels on US naval vessels is 140oF (60oC)