0
What is the name of the hold down screw that holds down the front of the seat on a yfz 450?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the 1 cylinder post position on the distributor cap in relation to the hold down screw?
If it a 350, it is the front left post looking at it from the front bumper.
What are the cones on bikes?
the cones on any kind of bike are the thing that holds the bearings in the front hub so it can spin they screw on the axle and they hold in the bearings and that + the cup (AKA bearing race )is what the they spin on
How do you remove a fuel filter on a zafira?
underneath the car on the passenger side just in front of the rear wheel there is a bracket which holds the fuel filter,it is a torque screw which holds it on. it has two clips which hold the pipes on either end,these can be tricky to get off. hope this helps.
How do you make your quadarjet four barrel carburetor open faster?
I used to mess with my old quadarjet all the time on my old classic. There is a the secondary butterfly flap right. Underneath towards the secondary is a Allen screw underneath that holds a tension screw you can see on the side. Its a bit tricky to get the tension just right. Just have the Allen wrench handy with the small screw driver you will need....and hold the screw steady as you loosen the Allen screw (which is just the hold down) The flat head screw puts the tension on the secondary, the Allen just holds the tension in place. I found on my 650 quadarjet about 1 or 1 and 1/2 turn on the tension screw was enough......NOBODY likes to BOGGED DOWN!!!!
How do you remove the battery when the screw that holds it breaks?
With great difficulty. The hold down is a block at the bottom that holds the lip of the battery, and there is a big long bolt that screws in to hold it down. I'm assuming that bolt broke. Start by disconnecting the battery, and you may want to remove some of the shrouds around it to give yourself some working room. Cut off the bolt as close to the hold down block as you can, ideally so it's flush with the surface of the block. Then, drill it out. Replace the bolt with a larger one, or just get a different hold down from your local auto parts store.
How do you remove the battery from a 2007 Softail Deluxe?
Remove the screw at the back of the back seat, then the two screws that hold down the front seat and there is your battery. Please remove the negative cable first.
Why does Aaron grandmother hold the mirror in front of the bird and Aaron?
Aaron's grandom holds the mirror in front of the bird to show how beautiful they are. She holds a mirror out for Aaron because...................SHE SMOKING CRACK!
What holds the slide down on a microscope?
A pair of slide clips on the viewing stage hold down the slide.
How do you install brass address plaque on brick?
Use a drill bit that works on brick, drill a hole big enough to hold a metal dowel that will hold the screw that holds the numbers.
Can you please tell me the step to step process on which holds better wood a nail or screw?
don't know what you mean by step by step process, but I can say with confidence that a screw will almost always hold better.
What do bullfighters hold in front of the bull?
The matador holds a cape, either the capote de brega or a muleta.
Where is tire jack compartment on a 1991 Mazda mpv?
It is on the floor beside the front passenger seat right by the door under a plastic panel that is accessible by unscrewing a hold down screw that can be reached from behind the seat.
