The ignition switch. Where the key goes in is the key tumbler.
To changeÊthe ignition switch on a Hyundai Accent, first, one should remove the switch from the steering column, to which it is attached. From there, the component can be replaced.
Lower the steering colunm. the ignition switch is located on the top of the steering column about 6 inches from the firewall.
On the steering column
The ignition switch is located on the steering column right side, just below the steering wheel.
Disconnect the negative battery cable. Remove steering column covers Disconnect the electrical connector from the ignition switch Remove the screw retaining the switch to the steering column
On the steering column????
The ignition switch is in the steering column..that's where you insert the key to start the vehicle.
The ignition switch is usually mounted to the steering column and is operated by a linkage rod.NOTE On column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch:Remove the ignition switch wiring harness.Unbolt it from its position.Bolt the new switch into position.Attach the wiring harness.
Key is on steering column--control rod is connected to switch on lower end of steering column by brake pedal
you have to go under the dash and take out the steering column. and the ignition switch should have a wire going down to the bottom of the column coming from the ignition lock.
rightside bottom of steering column
Lower the steering column.