answersLogoWhite

0


Best Answer

990ml 10w 40 semi

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the oil measurement for a 140cc pit bike stomp?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much oil do you put in the fork tubes on a 1978 Honda 400 T Hawk?

My owners manual says 140cc or 4.7 ozs.


How do you oil your bike?

with W D 40 or just regular bike oil.. i usually oil my bottom bracket and headset bearings and the chain


How much oil for 2009 Honda 80cc dirt bike?

how much engine oil goes in an 80cc dirt bike


Why is your dirt bike blowing oil out the tailpipe?

Your bike is a 2 stroke. since you are mixing gas and oil together oil naturally blows out your tail pipe. if this is happening, then there is nothing wrong with your bike, unless it is a 4 stroke.


Does 2cycle oil go in gas tank or oil tank?

it depends if its a older bike you may have to put premix in (mix of oil and gas) in the tank if its a newer bike it will have oil injection and you only have to put oil in the oil tank and it mixes with gas in the carb, in any case try to get a manual for the bike in question it will tell you what to do


Can you put 4t oil in 2t bike?

If you mean 4 cycle oil in a 2 cycle bike, the answer is no. Use only 2 cycle oil in a 2 cycle motorcycle.


Where is the oil drain bolt for Honda crf150r dift bike?

at the botom of the dirt bike


How much oil does a 110cc pit bike take?

IT DEPENDS ON WHAT POCKET BIKE DO U HAVE


How many quarts of oil to fill an x moto 250 pit bike?

Approximately 1.5 quarts of oil fit into an X Moto 250 pit bike. You should be changing the oil in your pit bike at least every 2,000 miles.


Why does a dirt bike spit oil?

Its cool


How do you check the oil on a Suzuki motorcycle?

on flat ground balance the bike and check the little oil window usually on the right side of the bike on crankcase


How do you change the oil on a Yamaha TT 350?

To change the oil warm the bike up to normal operating temperature, then shut off the bike and remove oil drain plug below the left foot peg with an oil pan underneath the bike. then after all the oils has drained out add oil through the plug located on top of the clutch.