0
What is the part that connects in the tran that the speedo cable hooks into?
Wiki User
∙ 14y ago
Depending on your car you have one of 2 things the speedo cable hooks to in the trans. It iether goes directly in to a gear in side the trans or hooks to a gear box which redirects a secound cable to the trans speedo gear. good luck Don
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What part connects to the tranmisson to read the speed for a 1987 Chevy s10 5 speed?
A cable drives the speedo on that year of truck.
Can you fit a speedo cable and pedometer into clio 2001?
Yes, you can fit a speedo cable and pedometer into a Renault Clio 2001 model. You will need to order the part that is made for that make and model from your local auto parts store.
Where is the throttle body on a 1990 chrysler new yorker?
It is the part that the accelerator cable hooks to.
Speedo not working cable is ok part in 5speed tran not how do you fix it Toyota supra 1988?
You have to check a part between the cable and trans, theres a little part that connect the two, it gets worn.
How do you replace the speedometer cable on a 1991 Toyota Corlla standard?
If it has a mechanical speedo,take the negative battery cable loose first then take the spedo housing loose from the speedo first then pull the cable out of the housing. Then take the housing loose at the bottom and remove the part of the cable that is twisted off. Get a new cable and install it with lots of cable lubricant. Then hook up the botton end then the top end of the housing. Hook up the neg battery cable
How do you fix speedometer on Renault megane scenic 1997?
firstly you find the part off the speedo cable that's broken and then you replace it with a new part then you speedometer will work
What is a gear shift cable?
It is the part that connects the handle the driver moves with the linkage on/inside the transmission.
Where is the throttle position sensor located in a 1998 dodge diesel ram 2500?
It is on the part that the throttle cable hooks to on the engine.
The EIDE is connected to which part in a computer?
The enhanced IDE cable connects to your hard drive. It allows more information flow than a standard IDE cable.
How do you fix a speedometer and odometer on a 1971 VW Beetle?
In neither the speedometer or odometer work, then the best place to look is the cable. Jack up the left front of the car so that the left front wheel is not touching the ground. Take off the hubcap if it hasn't already fallen off. Take a close look at the 'grease cap'...it is at the very center of the wheel/hub. In the very center of that grease cap is a small cable. That cable drives the speedometer. Inspect the connection where the cable runs through the grease cap. There should be a wire cotter pin running thru the end of the cable to hold it in place. If you don't see anything poking thru the hole in the greas cap, then you probalby found the problem. You will have to try to fish the speedo cable end thru the grease cap hole, and fasten it with a wire cotter pin. Give the wheel a quick spin...as fast as you can. Take a real close look at the center of the grease cap...where the cable attaches. Verify that the cable is rotating with the revolution of the wheel. A common thing to wear out is the grease cap. It has a square hole in the end that the cable fits into. A common scenario is for the square hole to get rounded out, and also for the cable to round out...or even both will wear. This is the easiest thing to check. If the cable is not moving with the wheel...then you found the problem. Replace the grease cap and/or speedo cable. If the cable DOES turn, then have a friend look at the speedo and verify it hasn't started working. The next place to look if you have verified the cable is being 'driven' by the wheel is to look where the cable hooks to the speedo. Leave the front jacked up for now. Pop the hook open, and remove the dash cover...usually a black cover attached by a couple small nuts. You will be able to spot where the speedo is right away. Don't bump any wires or anything while you are mucking around in there. Unhook the speedo cable from the speedo by unscrewing the cable from the speedo. Pull the cable away from the speedo, and have your friend spin the wheel. Verify that the cable is turning. If it isn't turning...and it was turning when you checked the grease cap connection...then that means the cable is broken. You would need to get a new cable in this case. But...if the cable is turning, then we can now deduce be elimination that the speedo internally is hosed up. Don't bother trying to fix it...you would need to replace it. Get a used one from a junk yard. Pay close attention to which wires go where. Take a piece of paper and draw out which color wires run to where. Draw it as you see it looking at the back of the odometer. The speedo is attached by 2 screws or bolts on the sides. Loosten them, but not all the way. Twist the speedo...counter clockwise if I remember correctly, and it will come unlatched. Putting it back in is straight forward. Just reverse the dissasembly process. Finally, be careful when working around a vehicle that is jacked into the air. Don't put any part of your body that you don't want smashed under the vehicle at any time.
How do you fix the speedometer on a Mazda RX-7?
The Speedo cable runs straight to the transmission. Have you had any tranny work or service's done recently or have you done any off road driving. The cable could be loose or the part needs replaced. I would check the condition of the cable and make sure everything is tight. If that's ok I would just replace the part and see what happens. MY speedo didnt work for awhile until I figured out that it just came loose. I had the transmission replaced and I guess the tech didnt tighten down the speedo to the trans. Luckly the same shop noticed it when I came in for an oil chandge. Lucky me.
Where is the throttle body on a 2002 Chrysler PT Cruiser?
It is the part that the hose from the air cleaner hooks to.It is the part that the hose from the air cleaner hooks to.
