If it's a Mk2 Clio then the speedo is electronic - Mk1 Clios had cable driven speedos.
on a clio 172 ph2 (facelift )its not a cable its a sensor its on the gearbox just below the power-steering bottle it will cost you £25.35 On a clio 172 ph1 ( prefaclift) there is a cable, take off inner wing/plastic arch, peel back the sound guard. Once this is done disconnect the cable at both ends.. Next, at the bulk head pull the cable free, thread the new cable in and connect to accelerator and then to the throttle body, put on clip to hold the cable in place... put back sound deading and inner wing, all done..
if you mean the shaking of the needle you will need to have the speedo cable changed it is quite a simple job for someone with a bit of mechanical knowledge
How do you replace the clio front passenger seat cable
to change the speedo on a mk1 clio u a to take off top half of the dash there are screws by the window and screws when ypu open the door, then you have to take off the panels around the steering wheel, and the panel underneath that, then it is easy u will under stand frm there
To fit a speedo sensor to a 1998 Renault Clio, first ensure the vehicle is safely lifted and secured. Locate the speedo sensor, typically found on the transmission housing, and disconnect the wiring connector. Remove the old sensor by unscrewing it and install the new sensor in its place, ensuring it is securely fastened. Finally, reconnect the wiring and test the speedometer to ensure proper functionality.
Take dashboard out, then remove surround around the stearing and remove to to far screws
I have a Renault clio 2001 dynamique and it is in the front bumper on the drivers side! not sure if it will be the same on all clio but this helps!!
How do you reset the service light on a 2001 Renault Clio?" and can you take your seat out and take the air bags out and how is it done
asda where can I find a diagram of the wiring box on a 2001 Renault clio? please
To remove the speedometer (speedo) on a Renault Clio, you will first need to locate and access the instrument cluster behind the dashboard. You may need to remove the dashboard trim panels or covers to access the cluster. Once you have access, you can disconnect the wiring harness and mounting bolts securing the speedometer in place. Carefully remove the speedometer from the cluster and replace it with a new one if necessary.
501 capless bulbs