on a clio 172 ph2 (facelift )its not a cable its a sensor its on the gearbox just below the power-steering bottle it will cost you £25.35
On a clio 172 ph1 ( prefaclift) there is a cable, take off inner wing/plastic arch, peel back the sound guard.
Once this is done disconnect the cable at both ends..
Next, at the bulk head pull the cable free, thread the new cable in and connect to accelerator and then to the throttle body, put on clip to hold the cable in place...
put back sound deading and inner wing, all done..
Yes, you can fit a speedo cable and pedometer into a Renault Clio 2001 model. You will need to order the part that is made for that make and model from your local auto parts store.
yes you terd
no
Yes they would fit with the right seat rails attached
To fit a washer pump in a Renault Clio, remove the wipers and scuttle panels. Then undo the 3 nuts. Fit the washer pump and put back the 3 nuts.
where is the fuel filter on my Renault clio 1.4s w reg year 2.000
Yes they will but rear will reequire a smaller spacer to clear the rear damper.
I believe that a Renault 19 1.8 16v engine is the same as clio 1.8 16v engine and as long as you have the right brackets am sure it would
no i dont think it will they are totally different shape
hahazhahahahahzhahah......no
Yes it will, 1.5 dci was mounted in Clio II ph2, and as pH 2 was facelifting without any major changes in construction it should fit without any problems (using parts from pH 2 clio). It may be possible to even fit 1.9 dci engines as non-turbo 1.9 was mounted in clio before 1.5dci was introduced.
speedo connected to gearbox and connected to other end not brken but not working