answersLogoWhite

0

What else can I help you with?

Related Questions

What is the pilot screw setting for a Yamaha ttr90?

The pilot screw setting should be screwed in until it is snug (not tight), then backed out 1 and 3/4 turns.


What is the initial pilot screw setting on a 1982 virago 920?

2 turns out.


What is the pilot screw setting for a Yamaha YFM80?

turn clockwise till stopped, then 1 1/4 turn out is the basic setting


What are the carburetor adjustment settings om Honda ATC 110?

Use the following settings: Jet needle groove in the 3 rd position.Idle speed should be 1700rpm.Pilot screw setting 1983 model: 1-1/8 turns out.For the 1984 and 1985 models: Pilot screw setting is 1-1/4 turns out.


Pilot screw setting for 04 Raptor 350?

It should be approximately 2.25 turns out from fully screwed in.


Is the initial pilot screw setting on a 1982 virago 920?

turn clockwise till seated then one and a half turns anti clockwise basic setting


What is carb setting for Honda xr 80?

2 1/8 turns out from full in for the air screw.


What is the pilot setting for a PD15B carburetor on an 1987 Honda xl185s?

turn the pilot screw inuntil it just stops at the seat. Be careful to not over tighten it, it is very delicate and can break. Then turn it out 1 and a half turns. With the engine warmed up turn it in slightly until the engine just stats to sputter, then turn it out until the engine starts to run smooth our turn the pilot screw out from the 1 and a half initial setting until the engine RPM just starts to increase the turn it back in a hair bit to where the RPM just starts to come down.Good Luck


What is the air fuel screw setting on a 1985 Honda rebel 250?

2 turns out from seated is a good start


Fuel to air mixture for a Honda ct 110?

Try 1.5 turns out on the mixture screw for an initial setting.


How do you change a 2005 Honda Pilot remote key battery?

remove screw from base of key with a very tiny screwdriver or take it to the dealership to have it done.


How do i remove Honda rancher shift knob?

To remove the shift knob from a Honda Rancher, first, ensure the vehicle is in neutral and the ignition is off. Locate the set screw on the side of the knob, usually accessed by lifting a rubber boot if applicable. Use an appropriate tool, like an Allen wrench or screwdriver, to loosen and remove the set screw, then gently pull the shift knob off the lever. If it's stuck, wiggling it slightly while pulling can help.