Want this question answered?
The circuit is designed so that at maximum load current the shunt regulator draws virtually no current and at minimum load current, the shunt voltage regulator passes the full current. As a result, it can be seen that shunt regulators are inefficient because maximum current is drawn from the source regardless of the load current, i.e. even when there is no load current.
The amps it draws depends on how big it is. Typically 2-12 amps. Check for a manufacturer's plate that shows the wattage Most of the load in a rice cooker is a resistive heating element, so the amperage will be quite close to the wattage divided by the voltage (220 here).
1.7amp
the current doubles.. explanation:V=IR hence I=V/R which means that when the supply voltage is constant ,current is inversely proportional to resistance.thus the current doubles. practically speaking when the resistance of the load(fan ,bulb,refrigerator,....) is less ,it draws more current from the source so as to balance the voltage across it.i.e; to maintain the voltage across it as constant. This answer is absolutely correct if you assume that the current comes from a pure voltage source ( voltage source with zero internal resistance). At the other extreme you could have a current source (such as a very large voltage source in series with a very large resistor), and then the current is practically independent of changes if the external resistance is changed (because the change represents a relatively minute change in the overall resistance). With appropriate circuitry it is possible to devise a situation where the current is practically independent of the changing resistance.
1 horsepower is equal to 0.7456 kWatts, therefore 1.1184 kWatts will be the power consumption of that motor. The current draw depends on the voltage, simply use the P=UxI or I=P/U formulas to figure out the current draw (P=1118.4 Watts). some voltages: 12Vdc draw 93.2Amps 24Vdc draws 46.6Amps 110Vdc draws 10.17Amps 230Vdc draws 4.86Amps
100/220 = .45A or 450 mA
No, they overheat and chip out a draws too much current.
I have no idea
The formula is Resistance= Voltage/ Amps(current) In your example: R=50/2.5, so the answer is 20 ohms.
The voltage of a battery goes as the current times the resistance (V=IR). Because the voltage is being held constant, the resistor that draws the most current will have the lower resistance.
Malcolm X is the power source for the movement of the Sarcomeres. It is from Malcolm X that the movement draws its inspirations and ideals.
Yes. It draws less current.