Specs:
4 Channel
4 ohm: 80W per channel
2 ohm: 160W per channel
Bridged: 320W
Damping: >500
S/N Ratio: >110dB
Dimension: 2.375" x 10"
Length: 18.5"
THD: 02%
Power Input: 4 Guage
Freq. Resp.: 4.5-100k
I/P Sens.: .15-12V
X/O Slope: 12dB
X/O Freq.: 30Hz-4kHz
X/O Type: 2 way
Input Type: Adv. Inst.
Cooling Fan: Yes
QBass: QBass™
I got the rockford T1D212, am using a 2000W RMS, Sedona Series Class D Mono block Amplifier by precision. it's a great amp.
The RCA's from the amp will be arn to the CD player, then you need to connect the speaker's wire to the output + and - of the amp, this will cause the amp to have musical power from your radio, and the speakers to have the power from the amp..-Shocker
AMP connectors are used for power cords and sockets. They will help your power cord work.
No, you need at least a 1.5 amp power pack.
the final stage of a power amp is a current amplifier in a bipolar design and a voltage amp in a FET design.
the power suppy diode are probably shorted.
what kind of power wire?(a power wire for an amp maybe) what kind of power wire?(a power wire for an amp maybe)
Power and Precision An Introduction to Explosives - 2003 V is rated/received certificates of: UK:15
To power your speakers, and to ensure that your amp has enough power to power your subwoofers, you would need at least an amp of 750 watts true power.
High precision op amp offers wider output voltage swing and noise.
No, they only use the power drawn from the service. The fact that is is 220 amp or 110 amp makes no difference. It is the load that is applied that determines the amount used.
In a rectifier made of just diodes, the diodes have a voltage drop, resulting in a lower DC output voltage. By introducing an Op-amp, this voltage drop can be overcome. Since there is no voltage drop caused by the diodes, the rectified signal is not changed by the rectifier, so it is called a precision rectifier.