The metal (copper) extracted may be generally brittle and break easily.
Low Grade Ores make poor tools because it will break or melt easily when used during work unless strenghened by mixing with a higher grade ore.
Solder can be used on any grade of brass or copper.
in the future, there may be no copper ores left so other metals will need to be used, however other metals are more reactive than copper, so will eventually dissolve
Hard copper using silfoss for the joints, copper tubing using flare connections, and screwed black iron pipe. You should hire a Journeyman gas fitter and get a permit for any gas work done as if there is a problem, it won't be covered by your insurance!!!!
Lower copper level by using Zinc and Vitamin C
Basic copper carbonate is prepared by combining aqueous.
It is very hard and very expensive to remove the copper from that ore.
The metal (copper) extracted may be generally brittle and break easily.
The metal (copper) extracted may be generally brittle and break easily.
It is very hard and very expensive to remove the copper from that ore.
Solder can be used on any grade of brass or copper.
It's poor quality and not all the copper can be extraxted from it
orange/red tubing is requried to bend itCopper has a bendable grade see see the CDA drawn and annealed called HARD and soft copper
Vista Memory Diagnostics
my teacher asked me to analyze my problem before answering it
in the future, there may be no copper ores left so other metals will need to be used, however other metals are more reactive than copper, so will eventually dissolve
Using copper washers as opposed to using aluminum aren't to much more beneficial except for the fact that copper is more reusable. On the down side copper is more expensive.
=== === By the way I doubt very seriously your using copper pipes your using copper TUBING