Remove the distributor and set it up in a press or vise of some sort. Press out the roll pin that retains the gear and install new gear. This would be the time to use shims above the gear to minimize end play.
NO.
Yes.
No need to if the distributor was not moved.
Cap and rotor, yes. Points, no.
It is hard to see and to get to. But it's right behind the distributor.
yes. same place flat top
It's located in the distributor under the rotor.
restabbing distributor and setting time I'm replacing 4 cylinder motor in a 87 Chevy s10 how do I install distributor and get the truck in time
The egr valve on the 1999 vortec v6 is bolted to the intake valve. It is just behind the distributor.
It is the only electronic device that is in the distributor. remove the cap and rotor and you will see it.
when did Chevy vortec come out
1-6-5-4-3-2 clockwise on the distributor.