If you are using Xp then use this ...
1.) Rename windows folder to Windows1 or whatevr u like...
2.) Now Install another OS from windows only not from bios...
3.) And run setup as you run before for all...
Enjoy.
Thanks Regards
Mustaqueem khan
install a differential
no sorry it is not possible as the previous version will be over written by the newer version you upload, invest in a hard drive that way you can save one on the hard drive and the other on computer!
If you have single phase now, you have two options. One, is to install a three phase service or Two, install a roto phase device.
the speed sensor is located on top of the transaxle near where the right side drive axle is attached . remove the two wire electrical connector and the retaining screw and pull it out. reverse the procedure to install.
Two ways: -pick up an inexpensive external CD drive and use that to install the CD -put the CD into a shared CD drive on another computer, and connect to that drive over a network.
yes
Create two partitions in ur hard drive and install Windows '98 on Drive C and install Windows 2000 on Drive D to another partition.
You need to create a partition on your hard drive. You can then install separate OS on each partition. Run BIOS to select which partition to boot from.
yes
Raid Array.
Install Win XP on the first hard drive, then install Vista from Xp and on question about "what kind of installation do you want to have?" Answer "separate" installation. When it asks you "which hard drive are you going to use?" Choose the second one. Vista will create a boot list automatically.
This computer technology works on 'master and slave' technology. in this two similar type of devices can be attached to the same data port on the motherboard. In order to install a combo drive there are two possible conditions:-1. you already have a CD-ROM,CD-rw etc.2. this is your first drive. if you already have drive then plug the data cable of combo drive into the previous drive and then plug the power cable of combo drive drive into power supply of system . then turn on the system combo drive will appear as the slave of previous drive . The combo drive is ready to use. (In case of an OS other than win- xp, you are supposed to install a driver). If this is your first drive then plug the data cable of combo drive on the motherboard and plug the power supply and turn on the system drive will appear (in case of OS other than win- xp, you are supposed to insall a driver).