Xd
a
Those numbers tell the electrical input required to run the machine at its full load.Added:Unless it is a dynamo, then it is output!
With the right input shaft and altered bell housing connector plate, i could put a c4 on ANYTHING...
It depends on the furnace, they come in different sizes. There should be a data plate on or in the furnace which lists the input and output rating.
Output to a photographic plate.
You should look around at the whole package to get the OBD connector for Vauxhall Corsa 57 plate.
the input shaft has splines on it which connect to the clutch friction plate.
The purpose is to heat up a ingred
A more specific question would help however, speaking mechanically if the car is rear-wheel drive the output device to the rear wheels is called a differential or final drive unit, this unit splits the output of the propeller shaft which takes output from the transmission which takes output from the engine, into two separate outputs for each rear wheel. Relays use a small voltage input to create a large voltage output. In an automatic transmission the torque converter does all the work to match the speed of the vehicle with the engine output. The clutch in a manual transmission serves the same purpose but is operated by the driver. The flywheel sits at the output of the crankshaft and is mounted to a pressure plate and clutch. The exhaust tailpipe sits at the output of the catalytic converter (where fitted) and the end of the exhaust piping leading from the engine to the rear side or bottom of the vehicle. There are 100's of countless outputs mechanical, electrical and electromechanical on a car.
Engine creates turning motion, flywheel connects to engine, pressure plate holds clutch to flywheel thus allowing power to be transferred to transmission input shaft (via clutch), different gears are meshed between the transmission input and output shaft depending on where gear shifter is positioned, transmission output shaft is connected to differential gears which connects to axles, which connect to wheels.
if it has a connector it will be behind the license plate or you have to install one
You need the input voltage and maximum input current specs found on the name plate.