Want this question answered?
one of the main purpose of refractories in the boiler furnace is to
A waterwall in a boiler is any furnace wall that is comprised of refractory and tubes in a water-tube boiler. The tubes are evenly spaced and generally connect to headers which in turn are connected back to the main generating bank of the boiler. They serve a two fold purpose here in that they capture heat that would otherwise escape to the atmosphere and help heat the water in the boiler. And they also help keep the refractory cool (relatively speaking) This prevents spalling of the refractory.
the decay of boiler material by chemical or electrochemical attack by its environment is known as boiler corrosion
what gas boiler alleviates the need for a cwsc
boiler are working on same principal but automatic and manual boiler has difference that manual boiler working at single element loop and automatic boiler work at three element loop.single loop means when fuel increase mean load increase on boiler by adjusting fuel operator has to adjust steam drum level manualy , while automatic means when load increas, fuel increase steam drum level adjust automaticaly by watching fuel consumption.
one of the main purpose of refractories in the boiler furnace is to
Purpose of the boiler drum is to collect steam from all the various tubes in a boiler, and send it to the turbine to spin the generator
A deaerator device is a mechanism found on steam boilers. Its purpose is to remove oxygen and other gases from the water that is entering the boiler tank, since the presence of oxygen or gases can cause corrosion on the inside of the boiler.
A boiler functions by boiling water to a steam, which rises upwards. Keeping the hot water tank above the boiler helps keep the hot water hot, as well as allowing the steam to carry itself to the tank, instead of the hot water tank producing steam feeding back into the boiler.
So the steam can rise from the boiler to the hot water tank storage
The purpose of a biomass boiler is to generate heat by burning or converting mass to energy. It does this in an efficient and environmentally friendly manner.
It is a small, valve usually used to manually check if water is above the valve connection on a boiler or tank. There may be several of them at different heights on the boiler or tank. There is a handwheel on the valve, an inlet connection (which is attached to the boiler) and an outlet (usually left unconnected). When filling the boiler or tank, the try-cocks can be left open. Water coming from the try-cock means the tank is filled to at least that level. The valve is then closed.
Yes
enviromental pollution control
It is possible that the expansion tank on a boiler could have too much water and not enough air, causing leaking. To fix this problem, the tank should be adjusted to the right levels of each.
This depends on whether the hot water comes from a combination boiler or from a hot water tank with a header tank feeding it. For a combination boiler the fault would probably be at the boiler, possibly from scale in the heat exchanger. For the system that uses the header tank and a hot water cylinder it could be that the float valve in the header tank is stuck an there for it is not refilling the tank or debris has entered the tank and is blocking the outlet.
A wood boiler is a furnace that is cost efficent and economic. You can purchase them on your own and have them professionally installed.