The purpose of a drip tray is to protect water leaking to the floor service level. This is to prevent any water damage to the floor and or other floor areas.
The purpose of a drip leg in the gas piping is used as a device to capture dirt and debris from entering the furnace.
By drip and sprinkler system
its a type of moulding :)
A bed moulding is a moulding in architecture of a cornice immediately below the cornea.
moulding in agriculture is where scrapped in heaped up around a small surface of a plant
The resulting moulding with incomplete filling of the plastic resin is called in practice as short moulding.
Joshua Moulding is 6'.
What is 3 benefit for moulding
getting into the service mast
To stop rain water from entering the service stack.
Steven Moulding is 6' 3".