A load or a resistance
A measurement of opposition to electric current flow in a component or circuit.
The typical answer is current is zero when there is a break in the circuit. It depends on the complexity of the circuit, there may be other paths for the current to flow, such that if there is a break in one part of the circuit, the rest of the circuit still has current flow (but a different value than designed). If you are reading voltage, and there is a break then that will change, also depending on the complexity. If it is a single loop, and you're reading voltage before the break, your voltmeter will read the same voltage as the voltage source, since there is no current flowing between any resistors between the meter and the source. If you're reading voltage after the break then the meter will read zero (0) volts.
To measure Voltage which is the force pushing current :)
If you're connecting it properly, then I would have to guess that the multimeter is defective.
A negative KVAR reading can be eliminated by adding an inductor to the circuit.
By reading the manual cocerning circuit amperage
Spelt: AmmeterIt measures the current flowing around the circuit. In different places in the circuit, the reading may be higher or lower.
None.AnswerIt depends! A capacitor is an open circuit, yet a.c. current flows quite readily. And d.c. current will flow for a very short period of time.
It is when a group of people die in a circuit thanx for reading!!!!!!!!!!!!
Strength.
the importance of unity.
Yes, or a circuit with a resistance higher than the capability of the meter, which would be unusual.
The typical answer is current is zero when there is a break in the circuit. It depends on the complexity of the circuit, there may be other paths for the current to flow, such that if there is a break in one part of the circuit, the rest of the circuit still has current flow (but a different value than designed). If you are reading voltage, and there is a break then that will change, also depending on the complexity. If it is a single loop, and you're reading voltage before the break, your voltmeter will read the same voltage as the voltage source, since there is no current flowing between any resistors between the meter and the source. If you're reading voltage after the break then the meter will read zero (0) volts.
A load or a resistance
A measurement of opposition to electric current flow in a component or circuit.
cutting off or isolating an electrical circuit