0
What is the red circular warning light with a line in the center mean it is not oil or handbreak warning on the dash of suzuki 4x4?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you reset warning lite code on suzuki sx4?
how to reset suzuki sx4
Where is the oil filter located on a Suzuki gs 500 motorcycle?
The oil filter is located behind a circular cover in the lower front center of the engine. This picture may help: http://www.bikebandit.com/suzuki-motorcycle-gs500ek-1989-oil-filter-oil-pump/o/m6049sch236925
Where can you find pictures of warning lights on suzuki jimny?
on the dashboard in front of the big round thing
How do you turn off Tire pressure warning light on Suzuki Verona?
put air in your tires
2004 Suzuki Forenza What causes the hold warning light to flash?
Push the button that says "HOLD" next to your shift knob.
Will a 2006 Suzuki S83 seat fit a 1996 1400 suzuki intruder?
Yes, you just need to remove the center bracket (back seat bracket) on your bike
How do you find air bag sensor in suzuki forenza 2005?
It is located under the center counsel.
What does the warning light mean in a 2007 suzuki forenza when it is in drive and the 'D' has an x through it and starts flashing?
Your transmission sensor might be broken
Where is obd II connector on 2002 Suzuki Vitara?
The 2002 Suzuki Vitara OBD 2 port is on lower edge of dash, right of steering column; near center console
What is the -L warning lite on 89 suzuki sidekick dash?
the L means you are in low range in the transmission, ie 2 wheel drive low or 4wd low
Where is the location of obd conector on Suzuki grand vitara 16 year 1999?
The 1999 Suzuki Grand Vitara OBD 2 port is on lower edge dash, right of steering column; near center console
What is the torque and head bolt pattern of a suzuki reno 2007 valve cover gasket?
According to the manual I have, the torque setting is 18 Lb-Ft per bolt starting in the center and working outward in a circular pattern. Then tighten an additional 90 degrees (1/4 turn) per bolt three times following the same sequence each time.
