Want this question answered?
stacture beam............
Tension is a type of stress put on a mechanical device/structure that's trying to pull it apart.
Cement is strong because is it's molecular structure means it links together under tension, but will come apart easily if pulled length-ways.
Concrete is strong in compression, as the aggregate efficiently carries the compression load. However, it is weak in tension as the cement holding the aggregate in place can crack, allowing the structure to fail. Reinforced concrete solves these problems by adding metal reinforcing bars, glass fiber, or plastic fiber to carry tensile loads
based on the microstructure of gray cast iron, the graphite form flakes, which is tiny flakes that tend to weaken the matrix structure in tension. it tend to fail in diagonal shear.
stacture beam............
Religious class and interest are all a part of social structure and not social tension.
Snapping is what happens when tension surpasses an objects ability to handle the lengthening force.
wind, weight, compression, tension and push
Tension is a type of stress put on a mechanical device/structure that's trying to pull it apart.
compression, tension, or torsion
Proprioceptors
The Tension Capable Bearing can accommodate structure vertical loads that vary from compression to tension during seismic movements. This bearing can substantially reduce structural framing costs by preventing uplift of a primary structural member, and can eliminate concerns regarding potential structure overturning or large vertical earthquake motions
High tensile bolts are used , where maximum tension is possible in structure as in PEB structure rafter, or Hanging parts.
No you cannot. The governers for transimissions have set spring tension for that specific model transmission. If you install an incorrect governer you will find that you will have shifting problems, or no shift at all.
It depends on the kinds of stresses the structure is expected to resist. To resist cantilever stresses (bending - a combination of compression, tension, and sheer), the octet-truss is the strongest possible structure. To resist only tension a straight line, such as a cable, is the optimum structural geometry; and to resist only compression a lorimerlite framework is the strongest structural geometry.
Sag is provided in transmission lines in order to lessen the tension of the transmission lines. Sag literally means to be bend in shape. In overhead transmission lines , the difference in level between points of supports (towers or utility poles) and the lowest point on the conductor is called a sag. Explanation: While erecting an overhead line, it is very important that the conductors are under safe tension. If the conductors are too much stressed between the supports ( towers, utility poles), then the stress on the conductors may reach to an unsafe level and the conductor may break due to excessive pressure ( i,e tension). in order to permit safe tension in the conductors, the conductors ( i.e the transmission lines) are not fully stretched but are allowed to have a dip or a sag.