answersLogoWhite

0


Best Answer

No you cannot. The governers for transimissions have set spring tension for that specific model transmission. If you install an incorrect governer you will find that you will have shifting problems, or no shift at all.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you use the governor off a 700R4 transmission on a TH350 transmission?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What transmissions work with a 4.3 Chevy?

4L60E, 700R4, Th400, Th350. The 4.3L is basically a Small Block 350 with two cylinders cut off, so any transmission that works with a Small Block Chevy will mate to a 4.3.


What are the visual differences of a TH350 and TH400 transmission?

the th350 pan is more of a defined square shape with a corner cut off and the rear of the case is basically smooth. the th400 has more an undefined and not square pan with ribs or fins at the rear of the case.


On a Chevrolet th350 after the car is turned off transmission fluid pours out of the dipstick?

Sounds like a vent problem. Check the breather on top of the case to see if it's blocked.


Can you take transfer case off 4x4 700r4 and make it 2wd?

NO. You would also have to change the transmission and install a 2-wheel drive transmission. The center shaft in the 4-wheel drive transmissions are longer so the transfer case will work.


How do you drain tranny fluid 700r4?

Take the bottom pain off


How do you replace a governor gear on a thr 400 transmission?

The governor is behind a cover on the side of the tranny, the cover is held in by 4 bolts, undo the bolts ,take the cover off, then turn the governor counter clock wize as you pull it out.


Would like to put a complete 4.0 jeep motor and trans out of 2004 grand Cherokee into an old Chevy truck?

It could be done, but, IMO, not worth it. You'd be better off going with a GM small block and a 700R4 transmission.


What size transmission for a 1992 Chevy silverado 2500?

Most of these had the 4L60 (700R4 updated) Some had the 4L80 (overdrive lock up variant of the old 400) if the diesel, Big block or towing or off road option packages were included


How to put a 350 engine into a 89 Toyota pickup?

have to get a radiator for a eight cylinder, a new transmission(700R4), change the yoke off the driveshaft so its goes into the Chevy tranmission, probably a rear end with stronger gears, run a new exhauts or just get headers.... probably fix the motor mounts and the transmission mount....


How do you replace the governor on a 30RH jeep transmission?

Remove the tail housing. Remove the snap rings on the output shaft. Remove the small snap ring on the weight side of the govenor. Slide the valve and pin out the oposite side. Remove the 4 bolts that hold the governor to the governor support. Slide the governor off the output shaft.


How do you remove the governor off a Baja 90cc?

To remove the governor off a Baja 90cc refer to your owners manual. Many newer models do not have a governor.


How do you take off a governor on a 1999 Chevy s10?

It has no governor. Speed is controlled by the ECU.